Craftsman Pressure Injection Starting Procedure
1. Safety Precautions
Before starting any pressure washer, it's important to ensure you have the proper safety gear on like goggles, gloves, sturdy shoes, etc. Conveniently, most Craftsman models come pre-assembled, but double-check check all hoses are securely attached.
2. Assembling the Craftsman Pressure Washer
Attach the pump handle securely to the back of the pump unit if it is not already installed. The handle will activate the pump. Inspect and tighten any threaded hose connections. Connect the other end of the high-pressure hose to the spray wand handle firmly. Adjust the spray wand safety guard and nozzle.
For a Craftsman gas pressure washer, you need to pour the oil into the engine and pump. To let it run with high performance, choosing the best oil and suitable is the key.
3. Starting a Gas Pressure Washer
With the pressure washer fully assembled and on a level surface outside, you can now start the gas engine. Ensure the fuel valve is in the "On" position. Grab the starter rope handle firmly and pull it slowly until you feel some resistance. If it still won't start, check that the spark plug is firing by removing and reinserting it. Once the engine kicks over and starts, allow it to warm up for a few minutes adjusting the choke to "Run".
4. Using the Pressure Washer
With the engine or motor running, you're ready to start cleaning. Always keep one hand on the spray wand and one hand on the safety trigger for control. If you are a newbie and don't have any experience with how to use pressure washers, this article will be needed for you.
Twist the nozzle tip to change between fan, soap, spot, and other patterns. Wear proper protective gear like goggles, boots, and clothing. Watch for worn or loose hoses, leaks, or damage between uses.
5. Shutting Down and Storage
When you have completed your cleaning tasks, follow these steps to shut down safely. Release the trigger to stop the water flow from the spray wand. Return the wand to its holder on the machine or coil up the hose. Wash off remaining debris or residue from surfaces of the pump unit and wand using a bucket of water before turning off the fuel valve or pulling on the stop cord.
Storewand, hose, and accessories in a dry place protected from weather. For engines, apply a light coat of oil to the cylinder to prevent rust during periods of inactivity. Cover the machine with a tarp or place it in a garage shed if stored outdoors. We can only write as briefly as possible to convey enough information to you as quickly as possible, so to learn more about pressure washer storage and winterizing, you need to click on the link above.
Troubleshooting Tips When Using
Engine won't turn over – Check that it has fuel and the choke is being used properly. The spark plug may also need cleaning or replacing.
Engine is flooding – Replace or adjust the carburetor float. Make sure the fuel mixture is not too rich.
Low or no pressure – Check connections for leaks. Inspect pump valves or bags for wear. The pump oil may need changing.
Irregular spray pattern – Clean or replace the nozzle. Check for kinks or buildup in the high-pressure hose.
Conclusion
Taking the time to properly assemble, start up, and shut down a pressure washer is essential for safe and reliable operation. Familiarizing yourself with the start procedures specific to your machine's fuel or power type, as well as basic troubleshooting solutions, will help you avoid common startup issues that can be frustrating or costly to repair.
